Neotys.com

Unanswered question

Can calculating average request/s start after delay which is set in population parameters?

population parameters.jpg population parameters.jpg
population parame...
50.8 KB
September 22, 2017
Processed

I set the population parameter "delay" on 1000 s. This is needed in order to allow application to be up and running before starting performance test (on jenkins). But, average request/s is calculated from the start of the test and calculates that delay time too. So, for my application it means that instead of ~ 450 request/s my results show ~9 request/s.

population parameters.jpg population parameters.jpg
population parame...
50.8 KB
September 22, 2017
Processed
runtime.JPG runtime.JPG
runtime.JPG
48.6 KB
September 22, 2017
Processed
Vladana S.
Vladana S.

Vladana S.

Level
0
3 / 100
points
Answer count
2 answers
Category
NeoLoad Results
Author name
Vladana S.
Date
September 22, 2017
over 6 years ago
Hits
viewed 221 times
question
q

Answers

Nouredine A.

Nouredine A.

Level
4
5000 / 5000
points
Team

So if i understand your application is not up and running when your start your NeoLoad Jobs. Would it not be easier to manage that in Jenkins itself by adding a build step and only start the NeoLoad jobs when your application is ready?

Otherwise you could add a pre-monitoring step of 1000s so the calculation of the statistics starts only after that period. It is configured in the advanced settings of your scenario.

 

Author name
Nouredine A.
Date
answer
a
christophe M.

christophe M.

Level
4
5000 / 5000
points
Team

You may use an automatic filter to be defined on your Scenario that removes this wait time and maybe the ramp-up of the test.

Author name
christophe M.
Date
answer
a