Unanswered question

How to add a proxy when launching Neoloadcmd ?

Hello,
While running some tests launched with Jenkins my virtual users need a proxy configuration to reach some internet ressources. In my case, Jenkins is running from a Linux (with jenkins service account). I can't configure the proxy from the GUI ...
Is there an option to configure the proxy from an ini file ?
Thank you in advance.

Jean-Philippe G.
Jean-Philippe G.

Jean-Philippe G.

Level
0
42 / 100
points

Answers

Susan W.
Susan W.

Susan W.

Level
1
234 / 750
points

I also want to know the answer to this question... Did you find one?

Jean-Philippe G.
Jean-Philippe G.

Jean-Philippe G.

Level
0
42 / 100
points

Hello Susan,
First I advice you make a backup of your project (because I experienced project corruptions in the past using the solution below ...you'll use it if you experience connection issues).
Then you can actually configure the proxy from the load generator settings ...
This allow to chose a different proxy from different locations.
HTH

christophe M.
christophe M.

christophe M.

Level
4
5000 / 5000
points
Team

Or you can copy paste the proxy settings at config file level from a NeoLoad with GUI (from Windows) to the NeoLoad without GUI.

The file is controller_user.properties

Under windows the file is C:\Users\<user>\AppData\Roaming\Neotys\NeoLoad\v5.5\conf
Under Linux is under <user>/.neotys/NeoLoad/v5.5/conf (case to be checked)

Copy/Paste or Modify the section named "[Proxy]".